Eotech Target Pointer Illuminator Aiming Light Uživatelský manuál stáhnout pdf (Strana 71)

2-47

2.4.4 Zeroing on a 25-Meter Range. This procedure is used

to zero the AN/PEQ-2A to the weapons and distances listed

in Table 2-7. Refer to Tables 2-1, 2-2, and 2-3 for adjuster

rotation and resultant direction of shot group movement.

a. On a 25-meter zeroing target, mark the designated

strike point and designated strike zone for the

weapon you are using (see Table 2-7).

b. Mount the target on an “E” silhouette or other

suitable surface at 25 meters.

c. Mount the AN/PEQ-2A to the weapon.

d. Rotate the Mode Selector to Position 1 (AIM LO). If

necessary, install the Aim Neutral Density Lens Cap

to eliminate excessive blooming. In high ambient

light conditions, use Position 3 (AIM HI).

e. While looking through a night vision device, activate

the Aim Laser in continuous mode by double-tapping

the Fire Button.

f. Direct the Aim Laser at the center of the target.

g. Fire a 3-round shot group and note the center of the

shot group relative to the designated strike point.

Re-tighten Rail Grabber Bracket and the AN/PEQ-

2A thumbscrew.

h. Rotate the Aim Laser Adjusters to move the center

of the shot group to the designated strike point.

i. Fire another 3-round shot group and again observe

the center of the new shot group relative to the

designated strike point.

j. When 2 out of 3 rounds are in the designated strike

zone, the AN/PEQ-2A / weapon combination is

zeroed.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 97 98

Žádné komentáře

Eotech Target Pointer Illuminator Aiming Light Uživatelský manuál Strana 71